![]() Set the system in place and gently press down the main section and hold in place for about 15 to 30 seconds. Apply a tall, thick bead of Pro-SealOnce ot the bottom of the Water X-Tract main section. Your entire system of drainpipes should connect to a 6-inch. Then, install a 4- or 6-inch perforated drain line at the bottom of the trench, and backfill it with 4 inches of gravel. Wet or dry the Pro-SealOnce will create a long lasting watertight bond! Simply clean and sponge the floor free of dirt and grime. Line the trench with landscape fabric to keep surrounding soil out and keep the gravel porous so that water flows easily. Pro-SealOnce Adhesive was specially designed to bond the Water X-Tract System watertight to the cement floor, even in wet conditions! Pro-SealOnce is a moisture activated sealant. Pro-SealOnce is a new generation sealant exclusive to our system. Pro-SealOnce Adhesive bonds water-tight in wet conditions! Extended toe on the leading edge keeps the system upright, keeping the top tight against the wall, and adds an additional area for a watertight fillet of sealant along the leading edge. ![]() The key component to the success of the Water X-Tract System is the base design, using a concave ribbed base to hold sealant and compress sealant against the floor without the sealant escaping out from under it, creating a long lasting watertight bond. Water seeping in through the cold joint between the floor and walls is collected by the Water X-Tract System and quietly channeled around the perimeter to the sump pump. This non-invasive system is ideal for monolithic slabs. Water X-Tract drainage channel is an interior baseboard system designed to collect water seepage entering the basement through the joint where the floor and walls meet. The hollow baseboard cove system is adhered watertight to the concrete floor using the Pro-SealOnce Adhesive.
0 Comments
Leave a Reply. |