![]() Differential Mode shows the thickness variation from a pre-set thickness value. With reduction rate you can measure critical thickness metal thinning caused by bending.ĭifferential Mode and Reduction Rate Mode are standard features on all models. The result is that the Panametrics-NDT gages have earned a reputation for superior performance in measuring thick rubber, fiberglass, composites, and other tough materials. ![]() Not only can these gages use transducers as low as 0.5 MHz but their electronics (pulser-receiver) are highly optimized to process signals at these low frequencies. The 35HP gages are excellent tools to measure fiberglass or composite parts, from aerospace structures to boat hulls and storage tanks that require thickness control.įor more than three decades, we have developed the HP (High Penetration) series specifically for very sound-attenuating or thick materials. most thick or sound-attenuating materials.Typically these materials cannot be measured with most other ultrasonic thickness gages. With a very low ultrasonic frequency bandwidth and a special pulser-receiver, the HP gages are specifically designed to optimize ultrasound penetration when measuring thick, highly sound attenuating or sound scattering materials. resolution up to 0.001 mm or 0.0001 in.curved areas or containers with small radii.thin fiberglass, rubber, ceramics, and composite materials.metal containers, steel coils, machined parts as thin as 0.10 mm (or 0.004 inch).plastic bottles, tubes, pipes, sheets as thin as 0.08 mm (or 0.003 inch).In general, transducers with higher frequencies and smaller diameters allow measurements of thinner or curved parts and enhance the accuracy of the measurement. The 35 and 35DL can use transducers ranging from 2.25 to 30 MHz, which means that these versatile gages can solve the majority of thickness gaging applications, from very thin to very thick. Hand-held weighs only 0.24 kg (8.5 oz)ģ5 and 35DL are used in the majority of applications.Application Auto-Recall with default and custom setups. ![]()
0 Comments
Leave a Reply. |